[. . . ] ACT5 Digital Keypad Programming 30 SECOND PROGRAMMING GUIDE (for typical system) 1. [. . . ] wait required period} (Stop timing) {Buzzer stops -- timer set} Incorrect Code Lockout When three invalid codes have been entered in a row. During this time, the red indicator will flash and all user coded will be inactive. Press 0, then followed by the new programming code (four digits). Press to stop ­ this period is now programmed into the relay timer. Restoring Factory Defaults Note: The keypad may be returned to its factory default condition at any time by entering the programming mode and pressing the three times. (From Programming Mode) (Factory Defaults Restored & Keypad exits programming mode) If the programming code has been forgotten. Note: The keypad will not operate correctly without LK1 in place. Unit C1 South City Business Centre, Tallaght, Dublin 24, Ireland. Tel: 353-1-466 2570 Fax: 353-1-452 0427 Copyright 2003 Access Control Technology Ltd. (18-00001-27) As with any access control system, always ensure that there is an alternate means of escape in the event of the unit failing to operate due to power loss or in the event of fire. · · · · Don't forget to change the programming code to something known only to yourself. [. . . ] Always remember to factory default the controller before you start programming. For full details on the ACT product range and a list of distributors, Visit our website www. accesscontrol. ie INSTALLATION NOTES IMPORTANT ACT5 DIGITAL KEYPAD [. . . ]